DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects
3-22ADX16D-P (16-Port AUDIX Digital Port)
3
Station Lamp Updates Test (#16)
Station (Digital) Audits Test (#17)
Digital Terminal Remote Loop Around Test (1201)
NPE Crosstalk Test (#9)
This test verifies that this port’s NPE channel talks on the selected time slot and
that it never crosses over to time slots reserved for other c onnections. If the NPE
is not working correctly, one-way and nois y connections may be ob served. This
test is part of a port’s Long Test Sequence, and it takes about 20 to 30 second s to
complete.
Crosstalk testing is performed on both the primary infor mation channel (voice)
and on the secondary information channel (data) assoc iated with each DEFINITY
AUDIX port. If this test fails on either channel, the voi ce port is taken
out-of-service.
Table 3-9. TEST #9 NPE Crosstalk Test
Error
Code
Test
Result Description/Recommendation
1 ABORT During testing of the primary information channel, system resources may
not have been available. Also, the port may have been busy during the
test.
1. Check the port status. Use the display port PCSSpp command to
determine the voice port extension of the port. Use the status station
command to determine the service state of the port. If the port is in
use, it is unavailable for this test. Wait until the port is idle.
2. Retry the command at 1-minute intervals a maximum of 5 times.
2 ABORT System resources may not have been available, or the port may have been
busy during the test.
1. Check if port is being used, retry the command at 1-minute intervals a
maximum of 5 times.
1000 ABORT System resources required to run this test are not available. The port may
be in use. Use the display port PCSSpp command to determine the voice
port extension of the port. Use the status station command to determine
the service state of the port. If the port is in use, it is unavailable for certain
tests. Refer to “Status” commands in Chapter 8, "Maintenance Commands
and Trouble-Clearing Aids", for a full description of all possible states. Wait
until the port is idle before testing.
1. If the port status is idle, retry the command at 1-minute intervals a
maximum of 5 times.
Continued on next page