DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Commands
2-86display system-parameters maintenance
2
Modem Connection
On page 3 of the example for ms shown below, there are 11 fields that are hidd en
when the Modem Connection? field is set to none. In this example the Modem
Connection field is set to external, and these additiona l 11 fields are visible.
The first 2 fields on page 3 help setup the d ata format for the serial data from the
switch to the modem.There are only two valid c ombinations for these 2 fields:
■Data Bits = 8, Parity = None
■Data Bits = 7, Parity = (odd , even, mark, or space)
The remaining fields are listed below:
No. of Parties to Be
Conferenced Enter Digit
32
43
54
65
76
SPE Optional
Boards: These fields indicate whether a Disk c ircuit pack is p resent in the
system, and which Packet Interfac e slots are administered. If a
Packet Interface circuit pack is physic ally present, the
corresponding Packet Interface field is set to y when the sy stem
boots, and no chang e to that field is allowed. If the system is
equipped wi th duplicated SPEs, a Packet Interface field is set to y
when either SPE carrier contains a Packet Interface circ uit pack in
the corresponding position. If a Packet Interface c ircuit pack is not
present, then the value for the Packet Interfac e field is read from
translation data stored on di sk or tape. If the field is set to n, a
Packet Interface circuit pack may be administered by chang ing the
corresponding Packet Interface field to y.
Modem Connection None or external (none)
Modem Name This field is 20 characters long and will permit alp ha-numeric
characters to provid e a unique qualifier for a g iven modem. ( )
RTS/CTS Enabled This field will inform the modem that comm unication with the data
source UART will be driven with RTS/CTS flow control. This field is 6
characters long and is case in-sensitive. (&H1)
Asynchronous
Data Mode This field will configure the mod em as an asynchronous
communications devic e. This field is 8 characters long and is case
in-sensitive. ( )