DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects
3-54ANL-LINE (8-Port Analog Line), ANL-NE-L (8-Port Neon Analog Line)
3
■40975—indicates that the terminal eq uipment was on-hook when
ring-tip was detec ted during ringi ng. This usually indicates a failure
in the terminal equipment or the typ e of terminal has a low ringer
impedance. Call the terminal equipment and verify that the terminal
rings. If the terminal doesn’t ring , then replace it. Otherwise, issue
the test port PCSSpp command, and follow the proc edure for Test
#48.
■40977—indicates that no terminal eq uipment was connected when
ringing was attempted . Run the Short Test via the test port
PCSSpp command, and follow the p rocedure for the results of Test
#48.
b. This is a software audit error that does not indic ate any hardware
malfunction. Run Short Test Sequence and investigate errors (if any).
c. This error type indicates that the c ircuit pack has be en removed or has
been insane for more than 11 minutes. To clear the error, reinsert or
replace the circuit pack.
d. Test #48 may cause some terminal equipment to ring briefly during d aily
maintenance. If this ringing is disturbing the custome r or the terminal
equipment, it should b e disabled via the change station <extension>
command. However, on some releases of the software, this disables Tests
#6, #47, and #35 as well as Test #48.
e. Test #47 may cause a false alarm when the port is connected to
off-premises equipment, some non-voic e terminal equipment, and some
loop equipment. If this c auses a false alarm, then disable the test by
changing the Tests field of the change station command to "no."
f. Refer to "XXX-BD (Common Port Circuit Pack)" Maintenance
documentation.
System Technician-Demanded Tests: Descriptions
and Error Codes
Always investigate tests in the order p resented in the table below when
inspecting errors in the sy stem. By clearing error cod es associated with the
Battery Feed Test
, for example, you may also clear errors g enerated from other
tests in the testing sequenc e.