DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects
3-1124TIE-TRK (Tie Trunk)
3
Transmission Test (#844-848)
This test is non-destructive.
NOTE:
Tests #844-848 are not supported on an International switc h.
These tests are run by the Automatic Transmission Measuremen t System (ATMS).
They are not part of the long or short trunk test seq uences. Instead, they are run
on demand with the test analog-testcall command or as part of ATMS
scheduled testing .
The test call is run from an analog port on a TN798 Processor circuit pack. It
attempts to seize a port and make a call to a terminating test line ( TTL) on the
trunk’s far end. Transmission performance measurements are mad e and
compared to adm inistered thresholds. Errors are generated when results fall
outside of ‘‘marginal’’ or ‘‘unacc eptable’’ thresholds. Detail and summary
measurement reports are obtainable v ia the list testcalls command.
Table 3-496. TEST #844-848 Transmission Test
Error
Code
Test
Result Description/ Recommendation
1000 ABORT System resources required to run this test are not available. The port may
be busy w ith a valid call . Use display port PCSSpp to determine the trunk
group/member number of the port. Use the status trunk command to
determine the service state of the port. If the service state indicates that the
port is in use, then the port unavailable for this test. You must wait until the
port is idle before retesting.
1. If the port status is idle, then retry the command at 1-minute intervals
for a maximum of 5 retries.
1001 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals for a maximum of 5 retries.
1002 ABORT The system could not allocate timeslots for the test. The system may be
under heavy traffic conditions or it may have timeslots out of service due to
TDM bus errors. Refer to TDM Bus Maintenance to diagnose any active
TDM bus errors.
1. If system has no TDM bus errors and is not handling heavy traffic,
repeat test at 1-minute intervals for a maximum of 5 retries.
1004 ABORT The port has been seized by a user for a valid call. Use status trunk to
determine when the port is available for testing.
1. Retry the command at 1-minute intervals for a maximum of 5 retries.
1005 ABORT Trunk has been administered as incoming-only; transmission tests can
only be run on outgoing trunks.
Continued on next page