Lucent Technologies 555-233-119 Hybrid Line Remote Digital Loop Around Test (#59)

DEFINITY ECS Release 8.2 Maintenance for R8.2csi 555-233-119 Issue 1
April 2000
Maintenance Objects
3-697HYB-LINE (Hybrid Line)
3
Hybrid Line Remote Digital Loop Around Test
(#59)
This test checks the digital control pair from the port c ircuit to the terminal. The
on-board microproc essor sends a message to the ter minal and checks for a
proper return message. This test is repeated three times, with two out of the three
attempts passing b eing sufficient for this test to p ass. This testl runs if the station
is in-service or out-of-service.
0NO
BOARD The test could not relate the internal ID to the port (no board). This could be due to incorrect translations, no board is inserted, an incorrect board is
inserted, or an insane board is inserted.
1. Check to ensure that the board translations are correct. Use the list
config command, and resolve any problems that are found.
2. If the board was found to be correctly inserted in step 1, issue the
busyout board command.
3. Issue the reset board command.
4. Issue the release busy board command.
5. Issue the test board long command. This should re-establish the
linkage between the internal ID and the port. If this is not the case,
dispatch to check to ensure that there is a valid board inserted.
Table 3-293. TEST #58 Hybrid Line Local Digital Loop Around Test — Continued
Error
Code
Test
Result Description/ Recommendation
Continued on next page