DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects
3-45ANL-24-L (24-Port Analog Line)
3
Table 3-19. Test #36 Station Status and Translation Audits and Updates
Error
Code
Test
Result Description/ Recommendation
ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1004 ABORT The port was seized by a valid call during the test. The test has been
aborted.
1. Use the display port PCSSpp command to determine the station
extension.
2. Use the status station command to determine the service state of the
port.
3. If the port is in use, wait until port is idle and retry the command at
1-minute intervals a maximum of 5 times.
1005 ABORT The test was aborted due to a configuration problem. This test may not be
applicable, or it may be disruptive to terminal equipment other than a voice
terminal (for example, the modem pool member or Music On Hold).
1006 ABORT This port has been busied out by command, or taken out-of-service by the
failure of the NPE Crosstalk Test.
1. Look in the Error Log for error type 18 (port busied out) for this port. If
this error is present, release the port with the release station
extension command, and run the te st again.
2. Check the Error Log for error type 1025 (NPE crosstalk test failed) for
this port. If this error is present, investigate the errors associated with
the NPE Crosstalk Test #6.
3. Make sure that the terminal is connected and in service, and then
retest.
2000 ABORT Response to the test request was not received within the allowable time
period.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1 FAIL This does not indicate a hardware problem. The switchhook audit failed.
The other updates were not performed because of this failure. This may
occur when the audit is performed at the same time the terminal equipment
goes off-hook.
1. Use the status station command to determine when the port is
available and retry the command at 1-minute intervals a maximum of 5
times.
Continued on next page