Lucent Technologies 555-233-119 Circuit Pack Restart Test (#252)

DEFINITY ECS Release 8.2 Maintenance for R8.2csi 555-233-119 Issue 1
April 2000
Maintenance Objects
3-357CLAN-BD (Control LAN Circuit Pack)
3
Circuit Pack Restart Test (#252)
NOTE:
This test is destructive.
Execute this test (not part of either short or long demand test sequenc e) to reset
the circuit pac k only if there are PPCPU errors. This test fails if the circuit pack
does not return to a sane state after being reset. The circuit pack resets throug h
the SAKI Sanity Test (#53).
Table 3-155. Test #252 Circuit Pack Restart Test
Error
Code
Test
Result Description/ Recommendation
None ABORT Could not allocate the necessary system resources to run test.
1. Retry the command at 1-minute intervals, up to 5 times.
2. If the problem persists, escalate the problem.
1015 ABORT Port is not out-of-service.
1. Busyout the circuit pack (busyout board UUCSS).
2. Retry the command at 1-minute intervals, up to 5 times.
3. If the problem persists, escalate the problem.
2100 ABORT Could not allocate the necessary system resources to run test.
1. Retry the command at 1-minute intervals, up to 5 times.
2. If the problem persists, escalate the problem.
1, 2 FAIL The circuit pack failed to reset.
1. Retry command at 1-minute intervals, up to 5 times.
2. If the problem persists, pull out and reseat the circuit pac k.
3. If the problem persists, replace the circuit pac k.
PASS The circuit pack initialized correctly.
Continued on next page