DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Commands
2-23change synchronization
2
The following example shows the output for the change synchronization
command. “3” was entered in the stratum field.
Field descriptions
Stratum: Current synchronization stratum (3, 4)
Primary: First choice system synchronizatio n source (blank entry = no
synchronization); field valid only if stratum 4 synchronization is
specified.
Secondary: Second choice system sync hronization source (blank = no
synchronization); valid if stratum 4 synchronization selected
Location: Circuit pack loc ation of all administered DS1 circ uit packs (port
network, carrier and board slot)
Name: User-defined name for the DS1 circ uit pack (blank = no user-defined
name assigned)
Slip: If DS1 circuit pack has slip alarm, y; if not, n.
Port
Network: Display-only field spec ifying the port network that sup plies
synchronization through the tone c lock circuit p ack (valid for stratum 3
synchronization)
change synchronization Page 1 of 1
SYNCHRONIZATION PLAN
SYNCHRONIZATION SOURCE (circuit pack location)
Stratum: 4
Primary: _____ Secondary: _____
Location Name Slip Location Name Slip
NOTE: DS1 and BRI trunk sources will result in stratum 4, type II
synchronization
change synchronization Page 1 of 1
SYNCHRONIZATION PLAN
SYNCHRONIZATION SOURCE (DS1 circuit pack location)
Stratum: 3
Port Network: 1