DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects
3-294BRI-SET, ASAI-ADJ, BRI-DAT
3
The switch sent a message to the endpoint which did not respond in the
allotted time. This can happ en occasionally due to fa ilure of the
point-to-point signaling link or because of a p roblem in the BRI endpoi nt or
ASAI adjunct or Lucent adj unct. Execute the test station extension sh
command and p ay particular attention to the resu lts of the BRI Layer 3
Query Test (#629). If this test fails, follow the repair procedure for Test
#629.
b. This error type indicates that the c ircuit pack has b een removed or has
been insane for more than 11 minutes. To clear the error, replace or
reinsert the circuit pac k.
c. This error occurs when the endpoint d oes not respond to the service sta te
query message sent to the ad junct or the endpoin t. This error causes an
alarm to be raised. The alarm is retired w hen the switch receives a
response to the service state qu ery to the endpoint or the ad junct.
For BRI endpoints, the Aux Data field for this error contains "0." When it
occurs, execute the test station
<extension>
sh command and pay
particular attention to the results of the BRI Layer 3 Query Test (#629). If
this test fails, follow the repair proce dure for Test #629.
When this error occurs for an ASAI or Lucent adjunc t, the Aux Data field
indicates the state of the ASAI link or Luc ent link and whether an invalid
response or no response was received to the query from the switch , as
shown in Table 3-129:
Table 3-128. Error Type 2 Cause Values
Aux Data Timer Type
2 First T303 (SETUP timer)
3 Second T303 (SETUP timer)
4 T305 (DISConnect timer)
5 First T308 (RELease timer)
6 Second T308 (RELease timer)
10 T316 (RESTart timer)
12 T309 (Layer 2 Failure timer)
16 TM100 (Management Information Message timer 1)
17 TM200 (Management Information Message timer 2)
102 TASAI (ASAI Routing Timer)
Continued on next page