DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects
3-799MEDPRO (Media Processor MAPD Circuit Pack)
3
FAIL The circuit pack failed to return the circuit pac k code or vintage.
1. Retry the command a maximum of 5 times.
2. If the problem continues, and if the circuit pac k is one of the Port circuit
packs, replace the circuit pac k. Otherwise, if the circuit pack is part of
the SPE, use the procedure described in
Repla cing SPE Circ uit Pac ks
in
Chapter 5.
3. Retry the command a maximum of 5 times.
PASS Communication with this circuit pack is successful.
0NO
BOARD The test could not relate the internal ID to the port (no board). This could be
due to incorrect translations, no board is inserted, an incorrect board is
inserted, or an insane board is inserted.
1. Ensure that the board translations are correct. Administer the MedPro
interface if it is not already administered.
2. If the board was already administered correctly, check the error log to
determine whether the board is hyperactive. If this is the case, the
board is shut down. Reseating the board re-initializes the board.
3. If the board was found to be correc tly inserted in step 1, then issue the
busyout board UUCSS command.
4. Issue the reset board UUCSS command.
5. Issue the release board UUCSS command.
6. Issue the test board UUCSS long command.
This should re-establish the linkage between the internal ID and the port.
Table 3-343. TEST #52 Control Channel Looparound Test — Continued
Error
Code
Test
Result Description/ Recommendation
Continued on next page