DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects
3-262BRI-BD/LGATE-BD (ISDN-BRI Line Circuit Pack)
3
Notes:
a. This error indicates the circuit p ack totally stopped functioning or it was
physically removed from the system.
NOTE:
The alarm is logged ap proximately 11 minutes after the circuit p ack
has been removed and/or SAKI Sanity Test (#53) fails.
If the circuit pac k is not in the system, insert a circuit pa ck (in the same
slot as the error indicates) to resolve this error. Or, if the c ircuit pack is in
the system and the red LED is on, then follow the instruc tions for a Red
alarm in the ‘‘Control and Port Circuit Pack Status LEDs’’ section in
Chapter 1, ‘‘Maintenance for cs i systems’’.
b. This circuit pack h as been busied out via the busyout board PCSS
command.
c. Port(s) has(have) been administered on this circuit pac k but the circuit
pack is not physic ally present.
d. This error indicates transient c ommunication problems b etween the switch
and this circuit p ack. Execute the test board PCSS command and refer to
the repair procedures for the Control Channel Loop Around Test (#52).
e. An on-board hardware failure has b een detected by the c ircuit pack.
The reported aux data values c orrespond to the following d etected errors:
Reset the circuit pack b y executing the busyout board PCSS and reset
board PCSS commands. When it is reset, the circuit p ack executes a set
of tests to detect the presence of any of the ab ove faults. The detection of
one of these errors during initialization c auses the circuit pac k to lock-up
and appear insane to the system. See the repair p rocedure in footnote (a)
for error type 1.
f. This error is reported by the circ uit pack when it detec ts a program logic
error. While no action is required, this error may lead to errors of other
types being rep orted against this circ uit pack.
g. This error is reported by the c ircuit pack when it c annot update NPE
memory and read it bac k. This error type can be ignored , but may lead to
errors of other types being rep orted against this c ircuit pack.
4352 External RAM error
4353 Internal RAM error
4355 ROM Checksum error
4357 Instruction set error