Lucent Technologies 555-233-119 Loopback/Span Test Bit-Error Count

DEFINITY ECS Release 8.2 Maintenance for R8.2csi 555-233-119 Issue 1
April 2000
Maintenance Objects
3-1252UDS1-BD (UDS1 Interface Circuit Pack)
3
The list measurements ds1 summary command will disp lay the length of time the
test ran (
Test Duration field) and number of b it errors detected ( Loopback/Span
Test Bit-Error Count
field).
To restore the trunks or ports on the TN464F UDS1 Interface circuit pack to the
in-service state, execute the release boa rd command.
Table 3-535. TEST #1216 End Loopback/Span Test
Error
Code
Test
Result Description/ Recommendation
ABORT Internal system error
1. Retry the
test ds1-loop UUCSS end-loopback/span-test command at
1-minute intervals a maximum of 5 times.
1005 ABORT End Loopback/Span Test cannot be executed in the current configuration. To
run this test, the TN464F or later suffix DS1 board must be administered for
24-channel operation. The "Bit Rate" field on the DS1 circuit pack
administration form must be set to "1.544" for 24-channel operation.
1015 ABORT Ports on the UDS1 Interface circuit pack have not been busied out to
out-of-service.
1. Enter the busyout board UUCSS command to put all trunks or ports of
the UDS1 Interface circuit pack into the out-of-service state.
2. Retry the command.
Continued on next page