Lucent Technologies 555-233-119 Facility Test Calls, Trunk Test Call

DEFINITY ECS Release 8.2 Maintenance for R8.2csi 555-233-119 Issue 1
April 2000
Maintenance for csi systems
1-49Troubleshooting Features
1
pressed while on a trunk call. Us e of this feature is denied if there are more than
two trunks on a call. If the call is trunk-to-tr unk, the identification d isplayed is of
the last trunk added to the c all.
Facility Test Calls
The Facility Test Calls feature provides a voice terminal user the cap ability of
placing test c alls to access spe cific trunks, touch-ton e (DTMF) receivers, time
slots, and system tones. The test call can b e made by a local voic e terminal user
by dialing an access code.
NOTE:
For the ISDN-PRI Test Call feature, see ‘‘Troubleshooting the Outgoing
ISDN-Testcall Command’’ later in this chapter.
The following Facility Test Calls are described bel ow:
■‘‘Trunk Test Call’’
■‘‘Touch-tone (DTMF) Receiver Test Call’’
■‘‘Time Slot Test Call’’
■‘‘System Tone Test Call’’
Trunk Test Call
The trunk test call accesses sp ecific Tie or CO trunks. DID trunks ca nnot be
accessed.
To place a call:
1. Dial the Facility Test Call Feature Access Code (for example, 197, see
Note), and listen for dial tone.
NOTE:
The Facility Test Call Access Code (FAC) is administered on the
Feature Access Codes Form. The 197 FAC code used here is an
example.
2. Dial the 6-digit port nu mber PCSSpp
The channels on a DS1 trunk are addressed b y using the channel numb er
for the port number.
P = Port network number (1)
C = Carrier number (A=1, B=2, C=3)
SS = Slot number (01-10)
pp = Port number