DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects

3-1281WAE-PORT (Wideband Access Endpoint Port)

3
connections. If the NPE is not working correc tly, one-way and noisy connections may be observed. This test is usuall y only part of a port’s Long Test Sequence, and it takes between 20 and 30 seconds to compl ete.
Table 3-547. TEST #6 NPE Crosstalk Test
Error
Code
Test
Result Description/ Recommendation
ABORT System resources required for this test are not available.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1000 ABORT System resources required to run this test are not available. The port may
be in use on a valid call. Use the status access-endpoint <extension>
command to determine when the port is available for testing.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1001 ABORT System resources required for this test are not available.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1002 ABORT The system could not allocate time slots for the test. The system may be
under heavy traffic conditions, or it may have time slots that are
out-of-service due to TDM-BUS errors. The status health command can
be used to determine if the system is experiencing heavy traffic. Refer to
TDM-BUS Maintenance documentation to diagnose any active TDM-BUS
errors.
1. If system has no TDM-BUS errors, and if it is not handling heavy traffic,
repeat the test at 1-minute interva ls a maximum of 5 times.
1003 ABORT The system could not allocate a tone receiver for the test. The system may
be oversized for the number of Tone Detectors present, or some Tone
Detectors may be out-of-service. The list measurement tone-receiver
command displays information on the system’s tone receivers.
1. Look for TTR-LEV errors in the Error Log. If errors are present, refer to
TTR-LEV Maintenance documentation.
2. Look for TONE-PT errors in the Error Log. If errors are present, refer to
TONE-PT Maintenance documentation.
3. If neither condition exists, retry the test at 1-minute intervals a
maximum of 5 times.
1004 ABORT The port has been seized by a user for a valid call. Use the status
access-endpoint <extension> command to determine when the port is
available for testing. The port is available when it is in the in-service/idle
state.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Continued on next page