Lucent Technologies 555-233-119 NPE Connection Audit Test,

DEFINITY ECS Release 8.2 Maintenance for R8.2csi 555-233-119 Issue 1
April 2000
Maintenance Objects
3-1184UDS1-BD (UDS1 Interface Circuit Pack)
3
ab. Error 3900 is used to give status information on a CPE Loopb ack Jack
Test. The value in the Aux Data field indicates the status of the loopb ack
test.
ac. Error 3901 is used to give status information on a Far CSU Loopback Test.
The value in the Aux Data field indicates the s tatus of the loopback test.
ad. Error 3902 is used to give status information on a One-Way Span Test. The
value in the Aux Data field indic ates the status of the span test.
ae. Error type 3999 indicates that the circui t pack sent a large numb er of
control channel messages to the s witch within a short period of time. If
error type 1538 is also present, then the c ircuit pack was taken
out-of-service due to hype ractivity. If error type 1538 is not present, then
the circuit pac k has not been taken out-of-service, b ut it has generated
50% of the messages necessary to be considered hyperactive. This may
be completely normal during heavy traffic p eriods. However, if this error
type is logged when the circuit pac k is being lightly used, it may indicate a
problem with the circui t pack or the equip ment attached to it.
System Technician-Demanded Tests:
Descriptions and Error Codes
Investigate tests in the order they are presented in Table 3-328. By clearing error
codes associated with the
NPE Connection Audit Test, for example, you may also
clear errors generated from other tests in the testing sequence.
1. Test is currently running.
2. Test failed because loopback could not be ac tivated.
3. Test failed because test pattern could not be detected .
4. Test has been terminated.
1. Test is currently running.
2. Test failed because loopback could not be ac tivated.
3. Test failed because test pattern could not be detected .
4. Test has been terminated.
1. Test is currently running.
2. Test has failed because test could not be activated.
3. Test pattern was not received from the far end.
4. Test has been terminated.