DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects
3-556DS1-BD (DS1 Interface Circuit Pack)
3
2. The tests run on the ports of this circuit p ack are returning NO
BOARD.
3. A busy-out/release of the circuit p ack has no affect on test results.
4. A list configuration command shows that the circui t pack and
ports are properly insta lled.
The circuit pack is isolated from the system and all trunks of this circ uit
pack are placed into the out-of-service state. The system will try to restore
the circuit pack w ithin 15 minutes. When no faults are detected for 15
minutes, the DS1 Interface circuit p ack is restored to normal operation. All
trunks of the DS1 Interface circuit pac k are then returned to the in-service
state. If the error recurs after 15 minutes, then escalate thi s problem.
r. For later releases of G3V4 and beyond, only error 3073 will show t hat this
board is receiving Slips and the AUX data shows the last Slip coun t that
was reported.
s. For later releases of G3V4 and beyond, only error 3329 will show t hat this
board is receiving misframes and the AUX data shows the last misframe
count that was reported.
t. This error is not service-affecting and can be ignored.
u. Error 3900 is used to give status information on a CPE Loopb ack Jack
Test. The value in the Aux Data field indicates the status of the loopb ack
test.
v. Error 3901 is used to give status information on a Far CSU Loopback Test.
The value in the Aux Data field indicates the s tatus of the loopback test.
w. Error 3902 is used to give status information on a One-Way Span Test. The
value in the Aux Data field indic ates the status of the span test.
1
—
Test is currently running.
2
—
Test failed because loopb ack could not b e activated.
3
—
Test failed because test patte rn could not be detec ted.
4
—
Test has been terminated.
1
—
Test is currently running.
2
—
Test failed because loopb ack could not b e activated.
3
—
Test failed because test patte rn could not be detec ted.
4
—
Test has been terminated.
1
—
Test is currently running.
2
—
Test has failed because test co uld not be activated.
3 — Test pattern was not received from the far end .
4
—
Test has been terminated.