DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects
3-907PKT-INT (Packet Interface)
3
the
out-of-service
state. Therefore, it is expected that the repa ir procedures
associated with Abor t Code 1137 (out-of-service) would normally be followed
when failures with the Level 2 test occurs.
Test #885 executes differently depending on which instance of Packet Interfac e
is tested:
1. Packet Interface 1 (TDM Bus-based) - No hardware is tested. Only
operational firmware is tested.
2. Packet Interface 2 (Packet Bus-bas ed) - All three tests are executed.
Table 3-389. TEST #88 5 Private Looparound Tests
Error
Code
Test
Result Description/ Recommendation
1006
1137 ABORT Packet Interface is in the out-of-service state so normal maintenance tests
will not run on it.
1. Use the
display system-parameters maintenance
command to identify
which C-LAN circuit pack is administered with the Bus Bridg e. Verify
that the C-LAN circuit pack is present and is not alarmed.
2. Request a Packet Interface reset usin g the reset
packet-interface AS command. Refer to the Packet Interface
Reset Test (#889) repair procedures for further action.
1334 ABORT The Packet Interface command q ueue is full. This should be a temporary
condition caused by a high rate of commands b eing sent to a Packet
Interface. Continued operation with a full command queue will cause a
system WARM restart that may escalate to more severe restart levels.
1. Retry the command at 10-sec ond intervals, a maximum of 5
times.
2000 ABORT Response to the test request was not received within the allowable time
period.
1. Retry the command at 1-minute inter vals, a maximum of 3 times.
2500 ABORT Internal system error.
1. Retry the command.
NO
BOARD The Packet Interface is not detec ted as being p hysically present .
1. Reboot the system, then retry the command . If the NO BOARD
indication persists, rep lace the TN798 Processor circuit p ack.
Continued on next page