DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects
3-285BRI-PORT (ISDN-BRI Port), ABRI-PORT (ASAI ISDN-BRI Port)
3
2 FAIL For the TN556 or TN2208, received a status of Level 1 Pending
Activation-Endpoint Active which indicates a prob lem with the BRI
endpoint or ASAI or Lucent adjunct, the wiring to the endpoint or adjunct,
or the ISDN-BRI port.
For the TN2198, received a status of Level 1 Pending Activation. U
interface up S/T interface down, which indicates a problem with the NT1 or
the wiring between the NT1 and the BRI endpoint (S/T interface).
1. As necessary, check and repair the wiring between the circuit p ack
and the endpoint or adjunct. Execute the test port PCSSpp
command, and review the results of the Level 1 Status Inquiry test to
verify the repair. If this test is still failing, proceed to Step 2.
2. For BRI endpoints, try replacing the BRI endpoint(s) connected to the
port. For ASAI or Lucent adjuncts, follow the recommended repair
procedures of the manufacturer for link communication problems. For
the NT1, follow the recommended repair proced ures of the
manufacturer. Then execute the test port PCSSpp command, and
review the results of the Level 1 Status Inquiry test to verify repair.
3 FAIL Received a status of Level 1 Deactivated; the port is out-of-service.
1. Issue the status bri-port PCSSpp command to verify that the service
state of the port is out-of-service. If the service state of the port is not
out-of-service, proceed to Step 2.
2. If the port h as been placed out-of-service via the busyout port
PCSSpp command, try releasing the port by executing the release
port PCSSpp command. Then issue the test port long PCSSpp
command, and review the results of Level 1 Status Inquiry test. If this
test is still failing, proceed to Step 3.
3. After executing the test port long PCSSpp command, review the
results of all the tests. Follow the repair procedures for any tests that
fail. Verify repair of the problem by executing the test port PCSSpp
command and by determining that the Level 1 Status test passes.
4 FAIL For the TN2198 only:
Received a status of Level 1 Pending Activation, the NT1 has a loss of
power indicating a problem with the NT1.
1. For the NT1 follow the manufacturers recommended repair
procedures.
2. Execute the test port PCSSpp command, and review the results of the
Level 1 Status Inquiry test to verify the repair.
PASS This test indicates that Level 1 is activated, or that software has taken the
port out of service.
Table 3-122. TEST #621 Level 1 Status Inquiry — Continued
Error
Code
Test
Result Description/ Recommendation
Continued on next page