DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Commands
2-390upgrade software
2
upgrade software
This command upgrad es the software text image, the flash comp onent of the
LMM firmware, the MTP firmware, and the Processor Interface (PI) firmwares. In a
simplex system, the command ve rifies that a software card-mem is present a nd
then, if present, proceed s to reprogram the flash memory and perform a level-4
restart. During the restart of the system, the system tec hnician is prompted to
replace the software card -mem with the translation card-mem. Servic e is
provided up on completion of the system restart. Service d own time is 5-12
minutes.
!WARNING:

Be sure to save translations before this executing this command. It may

also be helpful to read the Feature Interac tions for this command bef ore

upgrading the sy s tem sof tware.

Time (ms) Time from the board to each intermed iate destination in
milliseconds. If an error oc curs at a node, the entry is repe ated
with an error code immed iately following the time. Error codes and
their meanings are:
! Unable to reach port
!N Unable to reach network
!H Unable to reach host
!P Failure between endpoints
!F Need frag mentation of data packet
!S Source return failure
!X Packet blocked by filter
IP Address The 32-bit network address.
Action/Object Qualifier Qualifier Description Permissions Defaults
Feature
Interactions
upgrade
software none init
inads
craft
none See below