DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Commands

2-352test journal-printer

2
Feature Interactions
The maintenance of a particular c omponent on a link sometimes interferes with the maintenance of the link itself. Maintenanc e can put a link comp onent in a busy state causing link set-up to fail. Frequent attempts at re-setup of a link may delay the recovery of a faulty c omponent due to the maintenance te st of a component only taking p lace when the component i s idle. Therefore, the
Action/Object Qualifier Qualifier Description Permissions Defaults
Feature
Interactions
test
journal-printer

pms-log

wakeup-

log

short
long

repeat

number
clear
schedule
Tests the link to the pms logging
printer (maintenance name =
PMS-PRNT)
Tests the link to the wakeup logging
printer (maintenance name =
JNL-PRNT)
Option for a brief series of
nondestructive diagnostic tests.
Option for a longer, more
comprehensive series of both
destructive and nondestructive
diagnostic tests.
Number of times each test in the
sequence is repeated (1-100)
This option causes the test sequence
(short or long) to repeat until the alarm
(if any) is cleared or a single test in the
sequence fails.1
Command is validated and then a
scheduling form disp lays to schedule
execution of the command. The
command is then placed in the
command queue and is executed at
the specified time. The information
displayed by the command is sent to
the system printer instead of the
screen.2
Exampl es:
test journal-printer pms-log l
test journal-printer pms-log l
schedule
test journal-printer wakeup-log r 2
test journal-printer wakeup-log r 2
schedule
test journ pm r 3
test journ pm r 3 schedule
1 If no alarms are registered against the maintenance object then the test sequence is run only once. The

long clear

option forces a clear of all alarms if no errors are encountered during testing . The
short clear
option only clears alarms
pertinent to tests in the short sequence.
2 Refer to the Report Scheduler and System Printer feature specification for more details.
init
inads
craft
Test
sequence
= short;
repeat = 1
See below