DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects
3-315BRI-SET, ASAI-ADJ, BRI-DAT
3
SPID Facility Test
This test is used to verify the wiring and op eration of the signaling link b etween
the switch and a endp oint or adjunct on a BRI interface. This test is not
executed from the administration terminal, but rather is executed by using a
BRI test set equipped with a display. The test set may replace the BRI set,
ASAI or Lucent adjunct und er test by plugging it into the same jack or by
bridging it onto the wiring at some point between the switc h and the endpoint (or
adjunct), thereby c reating a pseudo-BRI multipoint c onfiguration.
When plugged into the p ort in this manner, the test set establishes a sig naling
link connection with the switc h and attempts to comp lete SPID initialization by
using the Service SPID administered for the system (see the System
Maintenance Administration Form). If the test set d isplays the correct
1187 ABORT The circuit pack, port or station may have been busied out by a technician.
1. Look in the Error Log for Error Type 18 (busied out ) for BRI-BD,
BRI-PORT, or BRI-SET.
2. If this error type is present for BRI-SET only, then release the station via
the release station command.
a. If this error type is present for BRI-PORT and BRI-SET, the n relea se
the port via the release port PCSSpp command and run the test
again.
b. If the error is present for BRI-BD, BRI-PORT, and BRI-SET, then
release the circuit pack via the release port PCSSpp command
and run the test again. If the error is present for both BRI-BD and
BRI-PORT, then release the circuit pack via the release board
PPCSS command and run the test again.
NOTE:
When you release the circuit p ack, you release all ports asso ciated
with it. If certain ports still need to be busied out, use the release
port PCSSpp command to busy them out.
3. Make sure the terminal is connected.
4. Retry the command at 1-minute intervals a maximum of 5 times.
2012 ABORT Internal system error
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Table 3-137. TEST #630 BRI Set Audits — Continued
Error
Code
Test
Result Description/ Recommendation
Continued on next page