Lucent Technologies 555-233-119 2-231status bri-port

DEFINITY ECS Release 8.2 Maintenance for R8.2csi 555-233-119 Issue 1
April 2000
Maintenance Commands
2-231status bri-port
2
ASAI 0-63 Established blank blank Transitory state for ASAI adjuncts.
ASAI signaling is connects at Layer
2. Layer 3 Restart procedure does
not complete between switch and
adjunct.
1. Check the adjunct by following
the manufacturer’s
recommended repair
procedures.
2. Verify repairs by executing the
status bri-port PCSSpp
command. Determine that the
L2 state of the signaling link is
L3-Established.
BRI 0-126 Established ext blank Normal state for non-MIM initial izing,
fixed and automatic TEIBRI
endpoints.
BRI, ASAI 64-126 Established blank blank T ransitory state for aut omatic TE IBR I
endpoints which support MIM
initialization.
1. Verify that SPID administration
on the switch and endpoint are
consistent. Verify the repair by
executing the status bri-port
PCSSpp command. Determine
that the L2 state of the signaling
link is L3-Established.
Otherwise, proceed to Step 2.
2. Try to replace the endpoint.
Verify the repair by executing
the status bri-port PCSSpp
command. Determine that the
L2 state of the signaling link is
L3-Established.
BRI 64-126 L3-Established ext blank Normal state for automatic TEIBRI
endpoints supporting M IM
initialization.
Table 2-3. Status BRI-Port Command Interpretation — Continued
Endpoint
Type s
TEI
Range Layer 2 State
Voic e
Extension
Service
SPID Description / Recommendation
Continued on next page