DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects
3-101ANN-BD (Announcement Circuit Pack)
3
Announcement Checksum Test (#209)
Associated with every rec orded announcement is a c hecksum. In this test, the
SP checks a stored global c hecksum covering all recorded announc ements
against a calculated one and returns the results to the maintenance system. If the
global chec ksum failed, maintenance req uests the SP to check each individ ual
announcement’s checksum.
If the test fails, then it returns the total number of d efective announcements
found. In addition, assoc iated with each failure is an error in the Error Log (Error
Type 14). The Aux Data indicates the number of the first d efective announcement
Table 3-38. TEST #208 Angel-Speech Processor (SP) Handshake Test
Error
Code
Test
Result Description/ Recommendation
2000 ABORT Response to the test request was not received within the allowable time
period. If Error Type 1538 is present in the Error Log, follow the
maintenance strategy recommended for this Error Type.
2100 ABORT Could not allocate the necessary system resources to run this test.
ABORT Internal system error.
1. Retry the command at 1-minute intervals a maximum of 5 times.
FAIL Test failed. Circuit pack cannot b e used. Announcement speech
memory is cleared when this test fails. Therefore, when the problem
has been resolved, announcements must be rerecorded or
downloaded to the circuit pack.
1. Reset the circuit pack via the reset board PCSS command and then
run this test again. If the test continues to fail, replace the circuit pack
and then run this test again.
2. If there are recurring alarms on this circuit pack caused by this test
failing, replace the circuit pack even if Step 1 works.
!WARNI NG:
Replacing the circuit pack results in loss of integrated
announcements. See ‘‘General Notes’’ near the b eginning of th is
Maintenance documentation.
PASS The communications link between the two processors on the
Announcement circuit pack is functioning properly. User-reported troubles
on this circuit pack should be investigated using other circuit pack and
port tests. Refer to "ANN-PT (Announcement Port)" Maintenance
documentation for a description of the port tests.
Continued on next page