Lucent Technologies 555-233-119 3-858OPS-LINE (DS1 OPS Line)

DEFINITY ECS Release 8.2 Maintenance for R8.2csi 555-233-119 Issue 1
April 2000
Maintenance Objects
3-858OPS-LINE (DS1 OPS Line)
3
Table 3-372. TEST #7 Conference Circuit Test
Error
Code
Test
Result Description/ Recommendation
ABORT System resources required for this test are not available.
1. Retry the command at 1-minute inte rvals a maximum of 5 times.
1000 ABORT System resources required to run this test are not available. The port
may be in use on a valid call. Use the status station or status trunk
command to determine when the port is available for testing.
1. Retry the command at 1-minute inte rvals a maximum of 5 times.
1002 ABORT The test was aborted because the system could not allocate time slots
for the test. The system might be under heavy traffic conditions, or it
might have time slots out of service due to TDM-BUS errors. (The
status health command may be used to determine whether the system
is experiencing heavy traffic.) Refer to the TDM-BUS (TDM bus)
Maintenance documentation to diagnose any active TDM-BUS errors.
1. If the system has no TDM-BUS errors, is not handling heavy traffic,
and the port status is idle, retry the command at 1-minute intervals
for a maximum of 5 times.
1003 ABORT The system could not allocate a tone receiver for the test. The system
may be oversized for the number of tone detectors present or some of
the tone detectors may be out of service. Issue the list measurements
tone-receiver command to display basic information about the
system’s tone receivers.
1. Look for TTR-LEV errors in the error log. If present, refer to the
TTR-LEV Maintenance documentation.
2. Look for TONE-PT errors in the error log. If present, refer to the
TONE-PT Maintenance documentation.
3. If neither condition exists, retry the test at 1-minute intervals for a
maximum of 5 times.
1004 ABORT The port has been seized by a user for a valid call. Use status station
or status trunk command to determine when the port is available for
testing.
1. Retry the command at 1-minute inte rvals a maximum of 5 times.
1018 ABORT The test was disabled via translation.
1. You may want to determine why the test has been disabled before
you enable it.
2. To enable the test for the particular analog station being tested,
enter the change station extension command, and then change
the Test field on the Station form to y.
Continued on next page