Lucent Technologies 555-233-119 PPE/LANBIC Receive Parity Error Counter Test (#595)

DEFINITY ECS Release 8.2 Maintenance for R8.2csi 555-233-119 Issue 1
April 2000
Maintenance Objects
3-358CLAN-BD (Control LAN Circuit Pack)
3
PPE/LANBIC Receive Parity Error Counter Test
(#595)
This test is non-destructive. When the CLAN circ uit pack detec ts a parity error
with a received frame, it increments the PPE/LANBIC Receive Parity error
counter. This test reads and clears the counter, and may verify repair of problem.
Errors may indicate a problem with:
■This circuit pack
■A packet bus
■Another circuit pac k on the bus
Table 3-156. TEST #595 PPE/LANBIC Receive Parity Error Counter Test
Error
Code
Test
Result Description/ Recommendation
2000 ABORT Did not receive circuit pack test response within the allowable time period .
1. Retry command at 1-minute intervals, up to 5 times.
2. If the problem persists, reset the circuit pack (reset board UUCSS).
3. If the problem persists, replace the circuit p ack.
2100 ABORT Could not allocate the necessary system resources to run test.
2500 ABORT Internal system error.
1. Retry the command at 1-minute intervals, up to 5 times.
2. If the problem persists, escalate the problem.
1-10 FAIL Circuit pack detects parity errors. The Error Code indicates the value of the
on-board error counter.
1. Retry the command at 1-minute intervals, up to 5 times.
2. If the test continues to fail, execute the Packet Interface Test (#598) (test
board UUCSS).
3. If Packet Interface Test (#598) fails, see Packet Bus repair procedures.
PASS Circuit pack detects no errors.
Continued on next page