DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects

3-485DID-TRK (DID Trunk)

3
1000 ABORT System resources required to run this test were not available. The port may
be busy with a valid call. Use the display port PCSSpp command to
determine the trunk group/member number of the port. Use the status
trunk command to determine the service state of the port. If the service
state indicates that the port is in use, then the port is unavailable for certain
tests. You must wait until the port is idle before retesting.
1. If the port status is active but the port is not in use (no calls), then
check the error log for error type 513 (refer to the Error Log table for a
description of this error and required actions). The port may be locked
up.
2. If the port status is idle, busyout and release the trunk, and then retry
the command at 1-minute intervals for a maximum of 5 times.
3. If the test continues to abort, check for wiring errors toward the CO
which may cause the trunk to lock up.
4. If the wiring is OK and the test continues to abort, replace the TN753.
1004 ABORT The port was seized by a valid call during the test. The test has been
aborted. Use the display port PCSSpp command to determine the station
extension, attendant number, or trunk group/member number of the port.
Use the status station, status attendant, or status trunk command to
determine the service state of the port. If the service state indicates that
the port is in use, then the port is unavailable for certain tests. You must
wait until the port is idle before retesting. Attendants are always in use
(off-hook) if the handset is plugged in and the port is not busied out.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1018 ABORT Test has been disabled by trunk group administration. Verify that the
Maintenance Tests? field on the Trunk Group Form is set to n. To
enable the test, issue the change trunk-group x command where "x"
equals the number of the trunk group to be tested. Then change the entry
in the Maintenance Tests? field on the form to y.
2000 ABORT Response to the test request was not received within the allowable time
period.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Table 3-203. TEST #35 Port Diagnostic Test — Continued
Error
Code
Test
Result Description/ Recommendation
Continued on next page