DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects

3-484DID-TRK (DID Trunk)

3
Port Diagnostic Test (#35)

This test checks a port’s b attery feed circuitry. The battery feed circuitry is tested

for on-/off-hook detection, batter y shutdown, and battery reversal (WINK)

capabilities.

0NO
BOARD The test could not relate the internal ID to the port (no board).
1. Check to ensure that the board translations are correct. Translate the
board, if necessary.
2. Issue the busyout board command.
3. Issue the reset board command.
4. Issue the release busy board command.
5. Issue the test board command. This should re-establish the linkage
between the internal ID and the port.
Table 3-203. TEST #35 Port Diagnostic Test
Error
Code
Test
Result Description/ Recommendation
ABORT System resources required to run this test were not available.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Continued on next page
Table 3-202. TEST #33 Looparound and Conference Circuit Test — Continued
Error
Code
Test
Result Description/ Recommendation
Continued on next page