DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects
3-70ANL-LINE (8-Port Analog Line), ANL-NE-L (8-Port Neon Analog Line)
3
1005 ABORT The test was aborted due to a configuration problem. This code will result
under either of the following conditions:
1. This test may not be applicable, or it may be disruptive to terminal
equipment other than a voice terminal (for example, the modem pool
member or music on hold).
2. The circuit pack is one of the following:
— TN742 vintages 13, 14 and 15
— TN769 vintages 3, 4 and 5
1008 ABORT Could not allocate a ringing circuit for one of the following reasons:
■All the ringing c ircuits are in use, or
■The ringing generator is defective, or
■It is not wired correctly.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2. If the test continues to abort, look for RING-GEN errors in the Err or Log.
If an ABORT 1008 occurs for Test #48 on other circuit packs as well,
then the ring generator may be defective. If it does not occur on other
ports, then that circuit pack is currently using all 4 ringing p hases.
1018 ABORT The test was disabled via administration. The default for the 'Test' field on
the 'Station' form is 'y'; thus, you may want to determine why this field has
been set to 'n' on this station (this may be due to the ringing application test
48, which can be customer or terminal disturbing).
1. To enable the test for a particular station, enter change station
<extension>
and set the Test? field on the station form to y.
2000 ABORT Response to the test request was not received within the allowable time
period.
2100 ABORT System resources required to run this test are not available. Either a system
allocation to get information about the port or to put the port into a service
state failed or the attempt to put the port in connection with a tone source
failed (this could be a tone-clock prob lem). The tone-clock and tone
detectors cou ld be having a communic ation problem, for exampl e, the
companding modes could be out of synchronization.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Table 3-28. TEST #48 Station Present Test — Continued
Error
Code
Test
Result Description/ Recommendation
Continued on next page