DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects
3-1178UDS1-BD (UDS1 Interface Circuit Pack)
3
1. Make sure all conditions for ad ministration are met and that a
functioning UDS1 circuit p ack is inserted in the c orrect slot, or
2. Completely remove the UDS1-BD from the system using the
following steps:
a. Remove any administered DS1 trunks, access end points or
PRI endpoints associated with the c ircuit pack from their
trunk groups .
b. Execute the remove ds1 UUCSS and change circuit pack
UUCSS commands.
If all the administration condi tions are met for this circuit pac k and the red
LED is still on, follow the instructions for
LED Alarms with Error Type 1
in
Chapter 7.
b. The UDS1 Interface circuit pac k has been busied out by a busyout board
UUCSS command.
c. The UDS1-BD circuit pack is not c ompletely administered . To be fully
administered, the UDS1 circuit p ack must:
1. Have an entry in the circuit pl an via the change circuit pack
command,
2. Be administered via the add ds1 UUCSS comm and, and
3. Be physically inserted into the correct slot.
A DS1 (UDS1-BD and DS1-BD) differs from most circuit pac ks in that
inserting the circuit p ack into the switch is n ot enough to make the board
usable. It must also be admin istered with the add ds1 command.
d. No Aux Data: A wrong circuit p ack is inserted in the s lot where this circuit
pack is logic ally administered. To resolve this problem, either remove the
wrong circuit pac k and insert the logic ally administered circ uit pack OR
use the change circuit-pack command to read minister this slot to match
the circuit pack i nserted.
Aux Data 3: The 24/32-channel option jump er setting on the circuit p ack
does not match the option set on the DS1 circ uit pack administration for m.
The circuit pack must b e physically removed to see th e setting of the
jumper.
e. This error is associated with the Common Port Circuit Pack Maintenanc e
Test. Refe r to XXX-B D (Com mon Po rt Cir cuit Pack) Main tenan ce
documentation for details .
f. The UDS1 Interface circuit pac k has detected a transient hard ware
problem. The value in the Aux Data field ind icates the type of hard ware
problem.
4352 External RAM failure
4353 Internal RAM failure
4355 Internal ROM failure