Lucent Technologies 555-233-119 Control Channel Test (#296)

DEFINITY ECS Release 8.2 Maintenance for R8.2csi 555-233-119 Issue 1
April 2000
Maintenance Objects
3-1071TDM-BUS (TDM Bus)
3
Control Channel Test (#296)
This test tests the integrity of the Control Channel bus. It ensu res that
communication through the TDM Bus is op erational.
Table 3-473. TEST #294 or #295 Idle Time Slot Test on TDM Bus A or TDM Bus B
Error
Code
Test
Result Description/ Recommendation
none ABORT Could not allocate the necessary system resources to run this test. For
example, maintenance could be running on the Tone Detector circuit pac k
and it is using the CPTRs.
1115 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
number FAIL The error code indicates the numb er of bad time slots that were detected.
The cause of this failure is most likely due to a bad port circuit pack and
not the TDM Bus itself.
1. Execute the command again.
2. If the error persists, check the Error and Alarm Logs for alarms on port
circuit pac ks from the NPE Crosstalk Test.
3. Refer to the appropriate circuit pac k’s documentation to c lear the
circuit pack’s problem.
4. Test the TDM Bus again. If the error continues, refer to the ‘‘TDM Bus
Fault Detection and Isolation Procedure’’ described earlier.
PASS The success of this test indicates all the idle time slots that are supposed
to be idle are indeed idle. There is no noise on any of the idle time slots.
Continued on next page
Table 3-474. TEST #296 Control Channel Test
Error
Code
Test
Result Description/ Recommendation
any code
other than
1005
ABORT Internal system error
1. Retry the command at 1-minute intervals a maximum of 5 times.
1005 ABORT Since this test is valid only on the control channel bus, it aborts execution
when run on the non-control channel bus. This is a valid response. Use the
status system command to verify which bus is the control channel bus.
Continued on next page