Lucent Technologies 555-233-119 reset packet-interface, reset switch-control

DEFINITY ECS Release 8.2 Maintenance for R8.2csi 555-233-119 Issue 1
April 2000
Maintenance Commands
2-198reset packet-interface
2
For troubleshooting, see ‘‘status interface’’, ‘‘status link n’’, a nd ‘‘status
processor-channel’’ commands to loc ate problems before p erforming a reset
interface (link traffic is interrupted ).
!WARNING:
The interface command interrup ts operation of the AP, DCS, AUDIX, CMS or
ISDN-PRI.
reset packet-interface
The IO-Processor controls the one and only Packet-Interfac e. To reset the
Packet-Interface for R6csi, use the reset io-processor command. Because this
command is not used in this software release, the following error message
displays on the status line:
Command unavailable; use ‘reset io-processor’
reset switch-control
This command resets and initializes the switc h control hardware and fir mware.
Action/Object Qualifier Qualifier Description Permissions Defaults
Feature
Interactions
reset interface
location (cabinet-carrier-position) of the
processor interface (PI board). The
position determines cleared
processor interface circuit p ack.
first processor interface = 1
second processor interface = 2
init
inads
craft
none none
Action/Object Qualifier Qualifier Description Permissions Defaults
Feature
Interactions
reset
switch-control none none init
inads
craft
nms
none