Lucent Technologies 555-233-119 Figure 3-13. Path of the BRI Port Local TDM Loop Around

DEFINITY ECS Release 8.2 Maintenance for R8.2csi 555-233-119 Issue 1
April 2000
Maintenance Objects
3-279BRI-PORT (ISDN-BRI Port), ABRI-PORT (ASAI ISDN-BRI Port)
3
Figure 3-13. Path of the BRI Port Local TDM Loop Around
Table 3-120. TEST #619 BRI Port Local TDM Loop Around
Error
Code
Test
Result Description/ Recommendation
1000 ABORT The system resources required to run this test are not available. The port
may be busy with a valid call. Use the display port PCSSpp command to
determine the station extension or trunk group/member number of the port.
Use the status bri-port PCSSpp command to determine th e service state
of the port. If the service state indicates that the port is in use, then the port
is unavailable for certain tests. Wait until the port is idle before retesting.
1. If the port is idle, then retry the command at 1-minute intervals a
maximum of 5 times.
1002 ABORT The system could not allocate time slots for the test. The system may be
under heavy traffic conditions or it may have time slots out-of-service due
to TDM-BUS errors. Refer to TDM-BUS (TDM Bus) Maintenance
documentation to diagnose any active TDM Bus errors.
1. If the system has no TDM-BUS errors and is not handling heavy traffic,
repeat test at 1-minute intervals a maximum of 5 times.
Continued on next page
Tone
Generator Tone Detector
BRI Line
Board
TDM Bus