DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Commands
2-308status trunk
2

SPE Modes

status trunk
This command displays in ternal software state information for diag nosis and can
help locate facilities to whi ch the trunk is communica ting. If a trunk group numb er
is entered without a member numbe r, a list showing the status for each memb er
in the specified g roup displays. If a b oth the trunk group and member numbers
are entered, the status for only the spec ified member disp lays.
Simplex SPE Modes
active 1A SPE in a simplex system is always the active SPE
blank No 1B SPE in a simplex system
Busyout Modes
busyout/idle SPE busied out and there is no current maintenance ac tivity.
The ac tive SPE c an b e eit her a ctiv e or se lec ted.
busyout/entering SPE busied out and in the process of restarting the switch
software on this SPE. After the switch software finishes its
initialization, the standby SPE is available for maintenanc e
functions on the standby SPE.
busyout/testing SPE busied out, however, the switch software on this SPE has
been restarted and is c urrently in the process of exec uting a
test command.
busyout/
not-refreshed SPE busied out, however, the busyout spe-standby
command was executed at a time when the standby memor y
was not refreshed. The standby SPE is not able to perform any
maintenance or SAT-requested activities until a succ essful
refresh spe-standby command is executed .
busyout/
list-config SPE busied out, however, the switch software on this SPE has
been restarted and is currently executing a list configuration
command.
busyout/status SPE busied out, however, the switch software on this SPE has
been restarted and is c urrently in the process of exec uting a
status card-mem command.