DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects

3-275BRI-PORT (ISDN-BRI Port), ABRI-PORT (ASAI ISDN-BRI Port)

3
BRI Port Local LAN Loop Around Test (#618)
This test is destructive.

This test, which verifies the connectivity of a BRI p ort across the LAN Bus,

executes only if the port is out-of-s ervice. The test aborts if calls assoc iated with

the port are in-progress. Failures of this test ind icate either on-board faults

Table 3-118. TEST #161 Loop Around Test
Error
Code
Test
Result Description/ Recommendation
1000 ABORT System resources required to run this test are not available. The port may
be busy with a valid call. Use the display port PCSSpp command to
determine the station extension or trunk group/member number of the port.
Use the status bri-port PCSSpp command to determine th e service state
of the port. If the service state indicates that the port is in use, then the port
is unavailable for certain tests. Wait until the port is idle before retesting.
1. If the port status is idle, then retry the command at 1-minute intervals a
maximum of 5 times.
1004 ABORT The port has been seized by a user for a valid call. Use the status station
command for the station associated with this port and d etermine when the
port is available for testing.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1005 ABORT This test is not valid for this type of translation. Ports administered as
“ASAI” or “ADJK” can not run this test, because the B channels associated
with the port are not used by ASAI or Lucent Adjunct Links. This is a
normal condition.
2012 ABORT Internal system error
2100 ABORT Could not allocate the necessary resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1, 2 FAIL The NPE of the tested port was found to be transmitting in error. This
causes noisy and unreliable connections. Error code 1 indicates that the
NPE Crosstalk Test failed on Channel B1. Error code 2 indicates that the
NPE Crosstalk Test failed on Channel B1.
1. Replace circuit pack.
PASS The port is correctly using its allocated time slots.
1. To be sure that this is not an intermittent problem, repeat this test a
maximum of 10 times to make sure it continues to pass.
2. If complaints still exist, examine the station, connections, and wiring.
Continued on next page