DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-337BRI-SET, ASAI-ADJ, BRI-DAT
9
When this error occurs for an ASAI or Lucent adjunc t, the Aux Data field
indicates the state of the ASAI link or Luc ent link and whether an invalid
response or no response was received to the query from the switch, as
shown in the following table:
(See "Status BRI-Port" in Chapter 8, ‘‘Maintenance Commands’’, for an
explanation of the ASAI link states.)
For ASAI or Lucent adjuncts, the switch auto matically queries the adjunc t
every two minutes (and therefore the Layer 3 Query Test is not executed
for ASAI or Lucent adjuncts via a c ommand issued from the G3MT
terminal). While alarmed for this error, the switch m omentarily (for five
seconds) takes the assoc iated port out-of-servic e every 15 minutes. This
action is taken in an attempt to stimula te recovery actions to be taken by
the adjunct.
When this error occurs for an ASAI or Lucent adjunc t, the service
technician should:
1. Execute the test station extension command and pay p articular
attention to any tests which fail and p erform the associated rep air
procedures for those tests.
2. Check the health of the adjunc t by following the recomme nded
repair procedures of the ma nufacturer of the adjunct if the
preceding ste p does not resolve the prob lem.
3. The alarm condition persists an d, if the above steps d o not resolve
the problem, follow normal esc alation procedures.
d. This error and associated WARNING alarm are logg ed against an ASAI or
Lucent endpoint when the ad junct has asked the switc h to suspend
Maintenance on the ASAI or Lucent endp oint. Busying out and releasing
the ASAI station or ADJLK station will clear this alarm.
e. This error occurs when the endp oint sends more messages than the
switch can handle. The switc h suspends the recep tion of messages from
the endpoint for a short period of time. There is no repair procedure for this
error. If the condition persists, rep lace the endpoi nt.
Aux
Data ASAI Link State Error
102 13-restarting No response to RESTART message
104 13-restarting Invalid response to RESTART message
152 13-restarted No resp onse to Layer 3 query
154 13-restarted Invalid response to Layer 3 query
202 13-established No response to Layer 3 query
204 13-established Invalid response to Layer 3 q uery