DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures

9-1193PE-BCHL (PRI Endpoint Port)

9
As with Test #256 (Service State Audit), a PASS simply means that an approp riate message was composed and sent to the far-end terminal adapter. The ISDN Specification allows up to 2 mi nutes for a reply. If a reply is not received within the 2 minute window, a protocol time-out violation will b e recorded in the error log against the associated sig naling channel (ISDN-PRI Signaling Link Port, which is listed in the Error Log as ISDN-LNK; the Error Type is 1).
Table 9-475. TEST #257 Call State Audit Test
Error
Code Test
Result Description/ Recommendation
1019 ABORT An audit is already in progress.
1. Wait 2 minutes and try again.
1113 ABORT The signaling link has failed, so the system cannot send any messages on
behalf of this port.
1. Check the results of Test #255 (Signaling Link State Check).
1116 ABORT The port is in an out-of-service ISDN service state.
1. A call cannot be present if the port is in an ISDN out-of-service state, so a
call state audit would be inappropriate. No action necessary. (Use the
status pri-endpoint extension command to investigate the ISDN state of
the port).
1700 ABORT Rollabout video abort. The PRI terminal adapter associated with this PRI
endpoint extension is detached from the circuit pac k. This is a normal abort
when the rollabout video feature is enabled.
1. Reconnect the disconnected PRI terminal adapter or disable the rollabout
video feature on this circuit pack. To do the latter, enter change ds1
UUCSS and set the field lab eled ‘‘Alarm when PRI Endpoint Detache d ?’’
to ‘‘y.’’
2100 ABORT Could not alloc ate the necessary system resourc es to run this test.
1. Retry the command at 1-minute intervals for a maximum of 5 times.
FAIL Internal system error
1. Retry the command at 1-minute intervals for a maximum of 5 times.
PASS This switch sent a call state auditing message to the far-end terminal adapter
to verify the state of the call active on this port. If a call state mismatch is found,
then the call will be torn down within two minutes. If no call was active, then no
message was sent.
Continued on next page