DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-1273PKT-INT (Packet Interface Circuit Pack)
9
Table 9-502. TEST #888 Active-Standby Peer Link Test
Error
Code Test
Result Description/ Recommendation
1006
1137 ABORT Packet Interface circ uit pack is in the out-of-s ervice state so normal
maintenance tests will not run on that circuit pack.
1. Request a Packet Interface circuit pack reset using the reset
packet-interface CS command. Refer to the Packet Interface Reset Test
(#889) repair procedures for further action.
1139 ABORT The Packet Bus is alarmed.
1. Try to retire the alarm associated with the Packet Bus. Refer to the Alarm
Log via the display alarms command. Refer to the PKT-BUS Packet Bus
maintenance documentation for further action.
2. Retry the command when the alarm associated with the Packet Bus is
retired.
1336 ABORT Internal system error.
1. If you wish to run this test on the standby Packet Interface, you must first
make it active with reset system interchange. Be sure you understand the
implications exp lained in
Planned SPE Inter chang e
in Chapter 5, ‘‘Alarms,
Errors, and Troubleshooting’’.
1337 ABORT The test is not allowed to run sinc e a PNC (Port Network Connectivity)
interchange is in progress. A PNC interchange may be initiated on demand with
the use of the reset pnc interchange command or as a result of a recovery
action.
1. Wait 3 minutes and retry the command.
1338 AB ORT The te st is no t allow ed to r un sinc e a pla nned SPE i nterc hange is in p rogre ss. A
planned interchange may be caused b y 24 hour scheduled testing. During this
time the terminal will be held out of service but it should recover automatically
after 3 minutes.
1. Wait 3 minutes and retry the command.
1339 ABORT The test could not run on the standby Packet Interface circuit pack bec ause the
standby SPE is unavailable.
1. Ref er to the STBY-SPE main tenanc e doc umenta tion fo r infor mation on why
a standby SPE may be unavailable and what repair actions should be
taken. The status spe screen should indicate that handshake is down. This
may be caused by a variety of reasons such as the setting the SPE-SELECT
switches on the DUPINT circuit packs to the position of the active SPE, a
failure of the DUPINT circuit pack, or loss of power on the standby SPE. The
SPE Select ed fie ld
on the status spe screen will display
spe a
or
spe b
if
the SPE-SELECT switches are in the a or b position, respectively.
Continued on next page