Lucent Technologies Release 7 9-854FIBER-LK (Fiber Link)

DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4 June 1999
Maintenance Object Repair Procedures
9-854FIBER-LK (Fiber Link)
9
Table 9-329. TEST #237 Expansion Interface Neighbor Query Test
Error
Code Test Result Description/ Recommendation
1033 ABORT The EI circuit pack does not have a fiber link administered to it. There is not
sufficient data to run test. Since the test fiber-link command was run, the
expansion interface should be administered on a fiber link, therefore this must
be a software problem.
2000 ABORT Response to the test request was not received within the allowable time
period.
1. Run the test board UUCSS test separately for each EI endpoint on this
fiber link and follow the procedures for this test in the ‘‘EXP-INTF
(Expansion Interface Circuit Pack)’’ section.
2031 ABORT The attempt to send the message to the Expansion Interface circuit pack,
asking it who it’s neighb or is, was not successfu l.
1. Run the test board UUCSS test separately for each Expansion Interface
endpoint on this fiber link and follow the procedures for this test in the
‘‘EXP-INTF (Expansion Interface Circuit Pack)’’ section.
2100 ABORT System resources required to run this test are not available.
1. Run the test board UUCSS test separately for each Expansion Interface
endpoint on this fib er link and follow the proc edures in the EXP-INTF
section.
2500 ABORT Internal system error
1. Run the test board UUCSS test separately for each Expansion Interface
endpoint on this fib er link and follow the proc edures in the EXP-INTF
section.
1033 FAIL The Expansion Interface circuit pack under test cannot make contact with
opposite end Expansion Interface or Switch Node Interface circuit pac k.
1. Run the test board UUCSS test separately for each Expansion Interface
endpoint on this fib er link and follow the proc edures in the ‘‘EXP- INTF
(Expansion Interface Circuit Pack)’’ section.
2027 FAIL The Expansion Interface circuit pack has contact with the opposite Expansion
Interface or Switch Node Interface circuit pack, b ut it is the incorrect
Expansion Interface or Switch Node Interface circuit pack.
1. Run the test board UUCSS test separately for each Expansion Interface
endpoint on this fib er link and follow the proc edures in the ‘‘EXP- INTF
(Expansion Interface Circuit Pack)’’ section.