DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-1091MODEM-PT (Modem Pool Port)
9
Table 9-433. TEST #98 Modem Pool Conversion Resource
Looparound Test
Error
Code Test
Result Description/ Recommendation
1000 ABORT System resources needed to complete the test could not be allocated for the
digital section of the Modem Pool conversion resource. Ordinarily, this means
the conversion resource or other hardware used during the test was in use.
1. Wait 1 minute and attempt the test again.
2. If the conversion resource is in use, and it is absolutely necessary to test it,
the call will have to be dropped by issuing a busyout port UUCSSpp
command against the conversion resource. Run the test again. If the test
passes, release the port.
3. If the same error occurs while the conversion resource is idle, busy out both
Modem Pool conversion resources on the TN758 Pooled Modem circuit
pack containing the conversion resource under test. Rerun the test.
4. If the test continues to abort, replace the Pooled Modem circuit pac k and
retest.
1180 ABORT A Maintenance/Test Board digital port c ould not be allocated for this test. This
error is more closely related to the digital port on the specific Maintenance/Test
Board circuit pack used for this test than the TN758 Pooled Modem circuit p ack
itself. Therefore, any hardware testing or replacement activities will focus on the
Maintenance/Test Board circuit pack. Verify that the digital ports of the
Maintenance/Test Board are present if this error occurs.
1. Use the list config command to verify that both of the Maintenance/Test
Board digital p orts are present. The display should show entries for both
port 02 and port 03.
2. If the digital ports (02 and 03) are not present, refer to the M/T-BD
Maintenance doc umentation.
3. If the digital ports are present, retry the command at 1 minute intervals a
maximum of 5 times.
1181 ABORT No time-slots available to connect dig ital ports for the test.
1. Retry the command at 1 minute intervals a maximum of 5 times.
1182 ABORT Internal system error. Failed to connect the digital ports with time-slots.
1. Retry the command at 1 minute intervals a maximum of 5 times.
Continued on next page