DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-198ATM-EI (Expansion Interface Circuit Pack)
9
1395 ABORT This test cannot be run on an ATM-EI circuit pack if it is part of the
B-side PNC, and the duplicated PNC is not enabled.
1. If this test needs to run on this ATM-EI circuit pack, enable PNC
with the change system-parameters duplication command.
2. Prevent the system from doing a PNC interchange (set PNC
lock).
3. Repeat this test.
2000 ABORT Response to the test was not received within the allowable time
period for some of the DSPs.
1. If the board is in standby, reset the board and run the test again
once the board is inserted.
2. Check the Error Log for Error Type 1218 (bad DSP). If Error Type
1218 is not logged against this board, run the DSP test again
and see if the error persists.
2100 ABORT Could not allocate the necessary system resources to run this test.
2500 ABORT Internal system error
2751 ABORT All DSPs are busy (very unlikely).
1. Retry the command at 1-minute intervals a maximum of 3 times.
2752 ABORT The circuit pack in this location is not an ATM pack.
10XX, whe re
XX = DSP#
01-24
FAIL There is at least one bad DSP on the board. The 10XX value
indicates the DSP number that has failed the test. However, the
failure of these DSPs does not indicate that all of the DSPs failed.
1. Retry the command at 1-minute intervals a maximum of 3 times.
2. If the test fails with the same error code, replace the board.
30XX, whe re
XX = DSP#
01-24
FAIL At least one DSP has failed because the test tone was not detected
correctly after being looped through the DSP. The 30XX value
indicates the DSP number that has failed the test. The failure of these
DSPs does not indicate that all of the DSP failed due to incorrect tone
detection.
1. Run the tests for the Active Tone-Clock on the PN that contains
the indicted ATM-EI circuit pack to verify that dial-tone is
supplied.
2. If the tone-clock is healthy, repeat the short test on the ATM-EI
board.
3. If this test continues to fail, replace the ATM-EI circuit pack.
Table 9-84. ATM Board DSP Test (#1258) — Continued
Error Code Test
Result Description/ Recommendation
Continued on next page