DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-1332PPP-PT (Control LAN Packet/Port)
9
1005 ABORT Test configuration is incorrect.
1. Verity PPP li nk is in-se rvice (status clan-port UUCSSpp or status link
n).
2. Verify routing table has reachable destinations.
3. Repeat the test.
1124 ABORT ppp link is not enabled.
1. Verify that the ppp link is enabled (status port UUCSSpp, status link
n
, or display data-module).
2. If the link is not enabled, enab le the link (change data-module).
3. Repeat the test.
1125 A BORT PPP link no t in servic e.
1. Verify whether ppp link is in service (status port UUCSSpp or status
link n).
2. If the ppp link is not in service, release the link (release link n or
release port UUCSSpp).
3. Repeat the test.
2000 ABORT Response to the test was not received from the CLAN circuit pack within
the allowable time period.
1. If this result occurs repeatedly, attempt to reset the circuit pack if the
other ports on the board are not in use (Yellow LED is off). Reset the
circuit pack (busyout board UUCSS and reset board UUCSS).
2. If this result occurs again, replace the circuit pack.
2012 ABORT Internal system error.
1. Retry the command at 1-minute intervals, up to 3 times.
2100 ABORT Could not allocate the necessary system resources to run test.
1. Retry the command at 1-minute intervals, up to 5 times.
2500 ABORT Internal system error.
1. Retry the command at 1-minute intervals, up to 3 times.
1003 FAIL Ping to the destination failed due to on-board problem.
1. Test the port (test port UUCSSpp) and verify Session Status Test
(#1286) result.
2. If this test indicates that all sessions on the port are down, escalate the
problem.
Table 9-520. TEST #1281 TCP/IP Ping Test — Continued
Error
Code Test
Result Description/ Recommendation
Continued on next page