DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-1688TBRI-PT (TN2185 ISDN Trunk-Side BRI Port)
9
The Deactivated state indic ates a problem with the TBRI-BD circuit p ack. When
in this state, the Level 1 interface is not ac tive, and an idle sig nal is transmitted to
the channels or that Layer 1 was deac tivated by the switc h. When an TBRI-PT
port is placed in the out-of-service state, Level 1 is also p ut into the Deactivated
state. This could be due eith er to the system detecting a fau lt with the port or to a
busyout port UUCSSpp request.
Table 9-635. TEST #1242 Level 1 Status Inquiry
Error
Code Test
Result Description/ Recommendation
1187 ABORT The board or port may be busied out.
1. Look in the Error Log for Error Type 18 (port busied out) for this port
and TBRI-BD (board busied out). If this error type is present for
TBRI-PT onl y, then release the port with the release port pp command
and run the test again. If the error is present for both TBRI-BD and
TBRI-PT, then release the board with the release board UUCSS
command and run the test again.
NOTE:
When you release a port, you release all p orts associated w i th it. If
certain ports stil l need to be busied out, use the release port
UUCSSpp command to busy them out.
2. Make sure the terminal is connected.
3. Retry the command at 1-minute intervals a maximum of 5 times.
2000 ABORT Response to the test was not received from the circuit p ack within the
allowable time period.
1. If the test aborts repeatedly a maximum of 5 times, reset the circuit
pack with the busyout board UUCSS and reset board UUCSS
commands.
2. If the test aborts again, replace the circuit p ack.
2012 ABORT Internal system error
2100 ABORT Could not allocate the nec essary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
Continued on next page