DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-488DID-TRK (Direct Inward Dial Trunk)
9
1000 ABORT System resources required to run this test are not available. The port may be
busy with a valid call.
1. Enter display port UUCSSpp to determine the station extension,
attendant number, or trunk group/member number of the port. Enter
status station, status attendant, or status trunk to determine the service
state of the port. If the port is in use, wait until the port is idle before
testing. Attendants are always in use (off-hook) if the handset is p lugged in
and the port is not busied out.
2. If the port status is active but the port is not in use (no calls), check the
Error Log for Error Type 513. The port may be locked up.
3. If the port status is idle, retry the command at 1-minute intervals a
maximum of 5 times.
1001 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1002 ABORT The syste m could not allocate time slots for the test. The system may be under
heavy traffic conditions or it may have time slots out-of- service due to
TDM-BUS errors.
1. If system has no TDM-BUS errors and is not handling heavy traffic, retry
the command at 1-minute intervals a maximum of 5 times.
1003 ABORT The system could not allocate a tone receiver for the test. The system may be
oversized for the number of Tone Detectors present or some Tone Detectors
may be out-of-service.
1. Resolve any TTR-LEV errors.
2. Resolve any TONE-PT errors.
3. If neither condition exists, retry the command at 1-minute intervals a
maximum of 5 times.
1004 ABORT The port was seized by a valid call during the test.
1. Enter display port UUCSSpp to determine the station extension,
attendant number, or trunk group/member number of the port. Enyer
status station, status attendant, or status trunk to determine the service
state of the port. If the the port is in use, wait until the port is idle before
testing. Attendants are always in use (off-hook) if the handset is p lugged in
and the port is not busied out.
2. Retry the command at 1-minute intervals a maximum of 5 times.
Table 9-200. TEST #6 NPE Crosstalk Test — Continued
Error
Code Test
Result Description/ Recommendation
Continued on next page