DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-106ANN-BD (Announcement Circuit Pack)
9
1024 ABORT This abort code ind icates any of the following :
■An announcement upload or download is in p rogress.
■An announcement upload or download was req uested while the test
was running.
■A recording sessio n was in progress.
■A recording session was initiated in while this test was running.
If an announcement upload or download is in progress, status data-module
extension should show that the announcement data port (17) is connected
to a data line port that is part of a system port, and the tape or disk should
be active. (To determine the extension of the announcement data module,
use the list data-module command.) See also
Locked Announcement
Circuit Pack
at the end of this table.
1. Wait until the cause of the abort finishes and run the test again. Upload
or download can take up to 45 minutes to complete. A recording
session is finished as soon as the station that was making the recording
is placed on-hook.
2. If the test continues to abort, and a recording session or
upload/downloa d is not in progress, esc alate the problem.
2000 ABORT Response to the test request was not received within the allowable time
period. If Error Type 1538 is present in the Error Log, follow the maintenance
strategy recommended for this Error Type.
2100 ABORT Could not allocate the necessary system resources to run test.
ABORT Internal system error.
1. Retry the command at 1-minute intervals for a maximum of 5 times.
Table 9-40. TEST #209 Announcement Checksum Test — Continued
Error
Code Test
Result Description/ Recommendation
Continued on next page