DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures

9-1117M/T-DIG (Maintenance/Test Digital Port)

9
This test will abort if an ISDN Test Call is in progress on either Maintenance/Test Digital Port when the test is requested, or if an ISDN Test Call is initiated while the Digital Port Sanity Test is in progress
Table 9-444. TEST #565 Digital Port Sanity Test
Error
Code Test
Result Description/ Recommendation
1000 ABORT One of the Maintenance/Test Digital Ports is busy with background
maintenance.
1. Either wait for the port to become idle, or busy-out both
Maintenance/Test Digital Ports on the Maintenance/Test circuit pack via
the busy-out port UUCSS02 and busy-out port UUCSS 03 commands,
respectively.
2. Release the ports (if they were busied out) via the release port
UUCSS02 and release port UUCSS03 commands, respectively.
3. Retry the command at 1-minute intervals a maximum of 5 times.
4. If the test continues to abort, escalate the problem.
1002 ABORT The system could not allocate time slots for the test. The system may be
under heavy traffic conditions, or it may have time slots out-of-service due to
TDM-BUS errors.
1. If the system has no TDM-BUS errors, and if not handling heavy traffic,
repeat the test at 1-minute intervals a maximum of 5 times.
2. If the test continues to abort, escalate the problem.
1004 ABORT The port was seized by a valid ISDN-PRI Test Call. Use the list isdn-testcall
command to determine which call is using the port (from the M/T Port
column). Either wait for the test call to complete (as indicated in the Start
Time and Duration fields of the above display), or abort the test call with the
clear isdn-testcall grp/mem command, where grp/mem is determined
from the B-channel field of the above display.
1019 ABORT An ISDN Test Call is in progress using this Maintenance/Test circuit pack.
The Maintenance/Test circuit pack cannot perform a self-test on one of its
Digital Ports while an ISDN Test Call is using either of the Digital Ports. Use
the list isdn-testcall command to determine which call is using the port
(form the M/T Port column). Either wait for the test call to complete (as
indicated in the Start Time and Duration fields of the above display), or abort
the test call with the clear isdn-testcall grp/mem command, where
grp/mem is determined from the B-channel field of the above display.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2. If the test continues to abort and the port is not in use, escalate the
problem.
Continued on next page