DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-826EXP-INTF (Expansion Interface Circuit Pack)
9
Table 9-314. TEST #336 Expansion Interface Reset Test
Error
Code Test
Result Description/ Recommendation
4 ABORT Could not reset the EPN Expansion Interface circuit pack over the optical fiber
since the neighbor Expansion Interface circuit pack or Switch Node Interfac e
circuit pack is not recognized by software (inserted).
1. Insert neighbor Expansion Interface circuit pac k or Switch Node Interface
circuit pack and perfor m reset again.
1015 ABORT The system will not allow this test to be run because the EI circuit pack has not
been busied out.
Busyout the EI circuit pack. Repeat the reset board UUCSS command.
2000 ABORT Response to the test request was not received within the allowable time period.
2100 ABORT Could not allocate the necessary system resources to run this test.
2500 ABORT Internal system error
1. Retry the command at 1-minute intervals a maximum of 3 times.
1 FAIL The Expansion Interface did not successfully reset.
1. If the EI circuit pack is in the EPN, the EPN Maintenance Board may be
holding the EI circuit pack reset. Attempt to rectify this condition by
executing the test maint P long command on the maintenance b oard in
the same EPN.
2. If Step #1 was not succ essful in releasing the Expa ns ion Interface circ uit
pack, temporarily remove the EPN maintenance circuit pack.
3. Repeat the reset board UUCSS command.
4. If reset continues to fail, replace circuit pack.
5. Insert EPN maintenance circuit pack if it was removed.
2 FAIL The Expansion Interface circuit pack was successfully reset, but it did not beg in
running after the reset.
1. If the Expansion Inter face circuit pack is in the EPN, temporarily remove the
EPN maintenance circuit pack.
2. Repeat the reset board UUCSS command.
3. Reinsert the EPN maintenance circuit pack if it was removed.
Continued on next page