Lucent Technologies Release 7 9-72ANL-24-L (24-Port Analog Line)

DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4 June 1999
Maintenance Object Repair Procedures
9-72ANL-24-L (24-Port Analog Line)
9
Table 9-31. TEST #48 Station Present Test
Error
Code Test Result Description/Recommendation
ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals for a maximum of 5 times.
1000 ABORT System resources required to run this test are not available. The port may
be busy with a valid call.
1004 ABORT The port was seized by a valid call during the test. The test has been
aborted.
1. Use the display port UUCSSpp command to determine the station
extension.
2. Use the status station command to d etermine the service state of t he
port.
3. If the port is in use, wait until the port is idle and retry the command at
1-minute intervals for a maximum of 5 times.
1005 ABORT The test was aborted due to a configuration problem. This test may not be
applicable or it may be disrup tive to terminal equip ment other than a voice
terminal (for example, the modem pool member or Music On Hold).
1008 ABORT Could not allocate a ringing circuit. Either all the ringing circ uits are in use
or the ringing generator is defective or it is not wired correctly.
1. Retry the command at 1-minute intervals for a maximum of 5 times.
2. If the test continues to abort, look for RING-GEN errors in the Error Log.
If an ABORT 1008 occurs for this test on other circuit packs as well,
then the ringing generator may be defective or is not wired correc tly
(see errors for RING-GEN). If it does not occur on other ports, then all
four ring phases are in use.
1018 ABORT The test has been disabled by administration.The default for the Test field
on the station form is y. Determine why this field has been set to n on this
station (this may be due to the brief ringing disturbance that this test may
cause).
1. To enable the test for a particular station being tested, enter change
station extension and set the Test? field on the station from n to y.
2000 ABORT Response to the test request was not received within the allowable time
period.
2100 ABORT Could not allocate necessary system resources to run this test.
1. Retry the command at 1-minute intervals for a maximum of 5 times.
Continued on next page