DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-1886UDS1-BD (UDS1 Interface Circuit Pack)
9
CSU Repeater Loopback Test (#1211)
This test is destructive.
The CSU Repeater Loopback (RLB) Test causes a loopback at the far-ed ge of
the local Lucent 120A1 CSU Module and tests the connection from the TN464F
DS1 board to and includ ing the CSU Module circuitry. This test will only be
performed if the Luc ent 120A1 CSU Module is present, administered, and
connected to a 1.544 Mb ps TN464F DS1 circuit pack on the b ack of the port
carrier.
The test is destructive and c an only be initiated by a system tec hnician
demanded
test ds1-loop UUCSS ds1/csu-loop back-tests
command.
All trunks or ports on the UDS1 Interface c ircuit pack must be busied out via the
system technician busyout board command before running the RLB Test.
When the RLB Test is initiated, maintenance software sends an appropr iate
message to the TN464F UDS1 Interface circuit pac k to start the test. The board
will set up the RLB loopback, transmit a test pattern, and verify that the pattern is
received unaltered through the loop back. If the transmitted and received pattern
is different, the test fails.
When the test is complete, all trunks or por ts on the TN464F UDS1 Interface
circuit pack are restored to the in-service state after the release board co mmand
is entered.
Table 9-698. TEST #1211 CSU Repeater Loopback Test
Error
Code Test
Result Description/ Recommendation
ABORT Internal system error
1. Retry the
test ds1-loop UUCSS ds1/c su-loopback-tests
command at
1-minute intervals a maximum of 5 times.
1005 ABORT CSU Repeater Loopback Test cannot be executed in the current configuration.
To run this test, the
Near-End CSU Type
field on the DS1circuit pack
administration form must be set to
integrated
and the "Bit Rate" field on the
DS1 circuit pack administration form must be set to "1.544" (24-channel
configuration).
1. Use the change ds1 UUCSS command to set the
Near-End CSU Type
field on the DS1 circuit pack administration form to
integrated
, and/or
change the "Bit Rate" field to "1.544" if the board is to be used in
24-channel configuration.
2. Retry the
test ds1-loop UUCSS ds1/c su-loopback-tests
command.
Continued on next page