Lucent Technologies Release 7 - page 322

DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4 June 1999
Maintenance Commands
8-11Common Abort and Fail Codes
8
1338 ABORT The system could not execute the c ommand on a component on
the Sta ndb y SPE bec ause an in terc hang e was p end ing .
1. Refer to ‘‘STBY-SPE (Standby SPE Maintenance)’’ in Chapter
9.
2. Try the command again after the SPE interchange oc curs.
1339 ABORT The system could not execute the c ommand on a component on
the Sta ndb y SPE bec ause an ha ndsh ake c ommun icat ion w as
down.
1. Refer to ‘‘STBY-SPE (Standby SPE Maintenance)’’ in Chapter
9.
2. Try the command again after the stand by SPE is restored to
service. Use status spe to dete rmine state of sta ndb y SPE.
1347 ABORT The system could not execute the c ommand on a component on
the Sta ndb y SPE bec ause memo ry ref resh w as not com plet e.
1. Refer to ‘‘STBY-SPE (Standby SPE Maintenance)’’ in Chapter
9.
2. Try the command again after the stand by SPE is restored to
service. Use status spe to dete rmine state of sta ndb y SPE.
1350 ABORT The system could not execute the c ommand on a component on
the Sta ndb y SPE bec ause memo ry sha dowi ng wa s not enab led.
1. Refer to ‘‘STBY-SPE (Standby SPE Maintenance)’’ in Chapter
9.
2. Try the command again after the stand by SPE is restored to
service. Use status spe to dete rmine state of sta ndb y SPE.
2012
2500 ABORT Internal system error.
2100 ABORT System resources to run this command were u navailable.
1. Try the command again at 1-minute interva ls up to 5 times.
Table 8-3. Common Error Codes for Busyout, Release, Test,
and Reset Commands — Continued
Error
Code Command Result Description/Recommendation
Continued on next page