DEFINITY Enterprise Communications Server Release 7
Maintenance for R7r
555-230-126 Issue 4
June 1999
Maintenance Object Repair Procedures
9-1528STO-DATA (Stored Data)
9
1347 ABORT Could not run the test on the Standby SPE—Refresh not complete.
1. When the standby SPE is restor ed to service (use status spe to determine
state of standby SPE) retry the command.
1350 ABORT Could not run the test on the Standby SPE—Shadowing not enabled.
1. When the standby is restored to service (use status spe to determine
state of standby) retry the command.
2000 ABORT Response to the test request was not received within the allowable time
period.
1. Retry the command at 1-minute intervals for a maximum of 5 retries.
2500 ABORT Could not run the test on the Standby SPE—Internal software error.
1. Retry the command at 1-minute intervals a maximum of 5 retries.
30004 FAIL The tape could not be read.
1. Verify a tape cartridge is in the tape drive.
2. Retry the command at 1-minute intervals for a maximum of 5 retries.
30014 FAIL An invalid file system was found.
1. Verify the correct tape cartridge is in the tape drive.
2. Otherwise, insert the correct tape cartridge and re-run test stored-data
long.
30201 FAIL The checksums of the boot images for the tape are inconsistent.
1. If a tape-only system, replace the tape. Follow the procedures presented
in the Section XXX of this manual.
2. If a disk/tape system, run backup disk full on the carrier containing the
bad tape (this could take up to an hour to complete).
3. Run test stored-data long to resolve the alarms.
PASS The checksums are consistent between the two boot images on the tape.
1. If other mss errors are present, refer to the maintenance information for the
HOST ADAPTER, TAPE, and DISK maintenance objects to clear those
errors.
Table 9-579. TESTS #829 and #830 Tape Checksum Tests — Continued
Error
Code Test
Result Description/ Recommendation
Continued on next page